Skip to content

Local water dashboard

Official source aggregation

Water quality in Roy, NM 87743

A source-transparent look at local hardness, associated public water systems, EPA compliance history, and the measurements that are—and are not—available for Harding County.

1 active health-based violation
Primary matched system
Roy (village Of)
Source water
Groundwater
County
Harding County
Profile updated

At a glance

What the current records say

Hardness

Very Hard

210.5 PPM · 12.3 GPG

Compliance screen

Review needed

1 active health-based record

Lead 90th percentile

0 mg/L

0% of action level

Utility match

1 system

Serves 498 people system-wide

Hardness meter

How hard is the water?

Very Hard

Estimated local hardness

USGS hardness classification scale

210.5 PPM

Soft
0–59
Moderate
60–120
Hard
121–180
Very hard
181+

Parts per million

210.5

mg/L as CaCO₃ equivalent

Grains per gallon

12.3

1 GPG ≈ 17.1 PPM

What this means at home

At 210.5 PPM, mineral scale can build up on fixtures and heating elements, reduce soap lather, and leave visible spotting. Hardness is primarily an aesthetic and appliance concern—not itself a tap-water safety rating.

USGS sites used

14

Nearest site

55.6 mi

Observation range

Jun 20, 2016–Jan 28, 2026

Estimate confidence

Low

Median of the latest qualifying hardness observation at each nearby monitoring site. Nearest monitoring location: 29N.28E.05.234 (Well).USGS source documentation ↗

Regional context

Is 87743 typical?

These comparisons use other indexed ZIP estimates, not utility tap samples. They help show local context without replacing a household test.

Roy median

211 PPM

About the same

1 indexed ZIP readings · Range 210.5–210.5 PPM

New Mexico median

228 PPM

17 PPM lower

194 indexed ZIP readings · Range 74.2–688.5 PPM

EPA benchmark screen

Contaminant snapshot

Available numerical results from associated SDWIS community water systems, compared with the applicable action level or federal MCL. Federal measured-value coverage is incomplete.

1 pass

Lead (PB90)

0 mg/L

Reported Dec 31, 2026

Copper (CU90)

Not available

No numerical 90th-percentile result

Numerical coverage

1 comparable result

Missing values remain blank; absence is not treated as a pass.

Lead (90th percentile)

Measured in mg/L

Pass

Local 0

EPA limit 0.015

Local level is 0% of the listed EPA limit.

Share of EPA benchmark

100% line = listed limit

EPA SDWIS compliance

Reported violation history

Open EPA source documentation ↗
2026Q2
All records
2
Health-based
1
Active health-based
1
Contaminant or ruleSystemStatusPeriod
LEAD AND COPPER RULE REVISIONSHealth-basedNM3526911AddressedOct 17, 2024
LEAD AND COPPER RULE REVISIONSNM3526911AddressedOct 17, 2024

No reported violation does not prove that every contaminant was tested or absent; SDWIS measured values are incomplete and lag state records.

Solutions matcher

Your personalized water action plan

Matched to Roy ZIP 87743 using 210.5 PPM nearby hardness and 1 reported measurement benchmarks.

2 matches

Scale protection

High-Capacity Whole House Water Softener

210.5 PPM is 2× the high-hardness trigger used by this matcher.

Designed to reduce scale on fixtures, water heaters, glassware, and plumbing throughout the home.

Compare whole-house systems

Drinking water protection

Under-Sink Reverse Osmosis System

LEAD AND COPPER RULE REVISIONS has a measured benchmark flag or active health-based SDWIS record in this profile.

A certified multi-stage RO system targets a broader range of dissolved contaminants at the kitchen tap.

Explore under-sink filtration

Affiliate disclosure: we may earn a commission from qualifying purchases, at no added cost to you. Product matching is educational and does not replace certified water testing.

Frequently asked

Water questions for Roy

Is tap water safe in Roy?+

EPA ECHO reports 1 active health-based violation among the associated community water systems. Review the affected utility's current notice and Consumer Confidence Report.

How hard is the water?+

Nearby USGS observations produce an estimate of 210.5 PPM, or 12.3 grains per gallon, classified as very hard. This is not a household tap measurement.

Do I need a water softener?+

At 210.5 PPM, a correctly sized whole-house softener can reduce scale and hard-water spotting. It does not replace contaminant filtration.